Dinan

D900-44TB7

Dinan Stage 1 Performance Engine Software/Boost Upgrade for BMW Alpina B7 L X F01 F02 2011-2012

Special Note: For 2011 and 2012 model years only. For B7, B7L, B7X and B7LX. See required products.
Product Description

Propelling it up that notch is the Dinan Stage 1 Performance Engine Software. As always, Dinan matches the new car warranty coverage for up to 4 years or 50,000 miles, including the possibility of consequential damages. No one offers better performance or backs it up with such comprehensive warranty coverage.

The Dinan Performance Engine Software safely increases turbo-boost pressure from the stock 14.0 to 18.0 psi, along with properly retuned fuel mixtures, ignition timing and full map rescaling. In fact, over 2000 lines of code have been addressed, producing substantial increases in power output while maintaining the civility and reliability expected of a Dinan performance product.

 

Note: When programmed, the pressure sensors in both intercoolers must be replaced with 2x BMW #13 62 7 585 494. Refer to TIS procedures 1362591 and 1362592. These sensors are not included with the software, and must be purchased separately from your BMW dealer.

Not legal for sale or use in California. 

 MODELS SUPPORTED
  •  2011-2012  Alpina B7 & L, X F01/F02
Product Specifications
Labor Hours/Installation Hours 1.50
Emission Status This product is in compliance with U.S. EPA Memorandum 1A, or this product has not been found, nor is believed to be, unlawful for use under the provisions of the Clean Air Act. Currently: This product is legal in California only for racing vehicles, which may never be used upon a highway.
Max HP Gain 80 hp @ 6500 rpm
Max Torque Gain 134 lb-ft @ 3500 rpm
Peak Horsepower 573 hp @ 5500 rpm
Peak Torque 644 lb/ft @ 3500 rpm
Peak HP Gain 73 hp @ 5500 rpm
Peak Torque Gain 128 lb/ft @ 3500 rpm
Factory Rated HP 500 @ 5500 rpm
Factory Rated Torque 516 @ 3500 rpm
Required Items Note: When the car is programmed, the pressure sensors in both intercoolers must be replaced with 2x BMW #13 62 7 585 494. Refer to TIS procedures 1362591 and 1362592. These sensors are not included with the software, and must be purchased separately from your BMW dealer or directly from DINAN at a discount.

Cars produced 3/12 and later will also require new sensor connector housings, 2x BMW #12 52 7 513 331. These connectors are not included with the software, and must be purchased separately from your BMW dealer.