Dinan Stage 3 Performance Software Upgrade for BMW Alpina B7 & L X F01-F02 2011-2012


Get the most out of your performance upgrades by receiving an additional 10 horsepower (over Stage 2) from the combination of the Performance Software and your Dinan intake and exhaust. Software upgrades are specifically designed and tuned for the Dinan upgrades.

Benefits of the Performance Software Upgrade:

  • Add 10 to 20 Horsepower when used in conjunction with Dinan performance intake and exhaust.
  • Downloads through the BMW diagnostic port, the same way BMW loads software
  • Top Speed Governor Removed, you decided how fast you want to go
  • Factory Matching Warranty Coverage (4year/50,000 mi), no sleepless nights or being scared to visit a BMW dealer
  • Full Map Rescaling, for drivability from idle to wide open throttle and everywhere in between
  • Properly Returned Fuel Mixtures, to save you gas and protect your engine
  • Retain All BMW Factory Engine Damage Safeguards
Special Note: 

For 2011 and 2012 model years only. For B7, B7L, B7X and B7LX. See required products.

  • 2011-2012 BMW Alpina B7 & L, X F01/F02
  • 2011-2012 BMW Alpina B7 Sedan
  • 2011-2012 BMW Alpina B7 xDrive Sedan
  • 2011-2012 BMW Alpina B7L Sedan
  • 2011-2012 BMW Alpina B7L xDrive Sedan 
Product Specifications:
Labor Hours/Installation Hours 0.50
Emission Status This product is in compliance with U.S. EPA Memorandum 1A, or this product has not been found, nor is believed to be, unlawful for use under the provisions of the Clean Air Act. Currently: This product is legal in California only for racing vehicles, which may never be used upon a highway.
Max HP Gain 96 @ 6500
Max Torque Gain 144 @ 6500
Peak Horsepower 587 @ 5500
Peak Torque 650 @ 3500
Peak HP Gain 87 @ 5500
Peak Torque Gain 134 @ 3500
Factory Rated HP 500 @ 5500
Factory Rated Torque 516 @ 3500
Required Items Dinan Free Flow Exhaust & Dinan Carbon Fiber High Flow Intake

Note: When the car is programmed, the pressure sensors in both intercoolers must be replaced with 2x BMW #13 62 7 585 494. Refer to TIS procedures 1362591 and 1362592. These sensors are not included with the software, and must be purchased separately from your BMW dealer.

Cars produced 3/12 and later will also require new sensor connector housings, 2x BMW #12 52 7 513 331. These connectors are not included with the software, and must be purchased separately