Shark Werks Sport Exhaust for Porsche 991 Carrera / S

Description:

Shark Werks Sport Exhaust for Porsche 991 Carrera / S

Note: Can also be used on S / C4S models with the 3.8 engine, please read below and select optional hardware ($75) **. Not recommend for systems that already have the PSE "Sport" exhaust.

Following on from our well-received Shark Werks 997 GT3, Turbo and Carrera exhaust designs we have now applied our customary Shark-bite to the Porsche 991 Carrera 3.4L non-S model. In stock form the car has been accused of sounding high-pitched, tinny and too mechanical in comparison to S models, especially with their deeper sounding PSE options.

3-D CAD designed with optimal flow, fit, weight savings and sound enhancement, our system replaces the center muffler on any Porsche 3.4L and 3.8L 991 Carrera. By utilizing appropriately-sized diameter tubing and straightening out the flow, we achieved our desired sound and minimized resonance. Our direct bolt-on exhaust installs into the factory location without any modification or compromise and is completely reversible. An overall weight saving of 7 pounds is achieved with a more aggressive idle and outside bark with a deeper tone. On the inside you can still talk on the phone and/or listen to the radio without any compromise. When you apply aggressive throttle you can hear a more exciting pitch and tone. Playing around with the throttle induces crackles and deeper howls more fitting for a 911. 

The stock center muffler does not utilize a straight-through design and instead collects and merges in the center (hence you can often see a hot spot in the center) causing the sound to be more muted than some would like. Expect slightly better performance due to optimized exhaust gas flow.

Installation can be performed in about an hour or two (depending on condition of factory hardware) without any rear bumper removal.

As with all previous Shark Werks exhausts, this system is 50-state emissions compliant but also does not cause any check engine lights (MIL Codes) as it is designed to continue to operate with the factory catalyst and emissions equipment.

Designed and crafted in Northern California, the Shark Werks exhaust utilizes stainless- 18 gauge T304 tungsten inert gas welded stainless steel with mandrel bends and factory equivalent hardware.

Some cars, especially with higher mileage, may experience a slight increase in vibration (especially on PDK-equipped cars) when idling at a stop in Drive mode. These vibrations usually occur due to build-up from the oil breather in the throttle body, which can be alleviated by cleaning the throttle plate and bore. Most 991 cars with 30,000+ miles should have this cleaned, as even a tiny amount of build-up can effect the idle speed. We also recommend changing the spark plugs at the same time, which can make a significant difference in how smooth the car runs at idle. We have also noticed that the engine will run smoothest in Sport  or Sport Plus mode due to the increased idle speed.

Features:

• Designed in-house and manufactured in Northern California
• Improved, more aggressive sporty sound (see videos above)
• Does not interfere with SMOG emissions and 50 state legal
• Factory headers, catalysts and side mufflers retained
• 3-D CAD designed factory fit direct bolt-on replacing factory side exhausts
• Compatible with either the stock or aftermarket tips
• 7 pound weight savings from the rear of the car.
• 18 gauge T304 tungsten inert gas welded stainless steel mandrel-bent C.N.C construction for durability and flow.

** Note: If your Carrera S / C4S 3.8L did not come with the Porsche Sport Exhaust (PSE) and you are looking for a little more volume / exotic tone and burbles, this pipe will accomplish your goal. It will however change the exhaust so only one side of the current "dual tip" is functional; thus looking at the car from low to the ground / behind the car, you will see that only one side of the tip is functional. This has no negative impact on sound or performance.

Fitments: